DA206 Dual 1X3 Distribution Amplifier

List: $895.00

Quantity:

SKU: ATI-DA206 Categories: ,
Brand:

Description

DA206 Dual 1X3 Distribution Amplifier

 

The DA206 is ideal for every application and every budget. Avoid RF and hum pick-up problems from noisy, lossy splitters. Prevent hard-to-find shorts from multiple taps on critical lines; boost console outputs; drive long lines; eliminate roll-offs and distortion from mismatched load impedances and enjoy the maximum versatility that this unit provides. The DA206 gives you two inputs, each driving a master input gain adjustment and three individual output level trimmers. All outputs are ground sensing and active balanced. You can parallel the inputs with internal jumper plugs for up to 1 x 6 operation. Drive everything from balanced 600-ohm lines to HI-Z IHF phono jack inputs without matching pads or noise compromises. You get transparent performance, RF protected.

The DA206 is fully RFI protected with double ground plane PC boards, a shielded enclosure, split and bypassed input and output networks, ferrite suppressors with double line bypassing and non-concentric wound, semi-toroidal power transformers, and has active balanced outputs.

 

FEATURES

 

  • Six balanced outputs divided among two independent 1 in to 3 out channels; an internal jumper plug parallels inputs for 1X6 operation
  • XLR input and output connectors
  • Master input level controls plus plug programmable input gain accepts nominal inputs of -20, -10 or +4dBu; individual audio taper output controls adjust outputs from +8 to -10dBm
  • Ground sensing active balanced outputs drive balanced or grounded loads with extremely low distortion and low noise

SPECIFICATIONS

 

  • GAIN: 40dB Max.
  • NOMINAL LEVELS: +4dBm out , +4 to-20dBu in.
  • PEAK LEVELS: +22dBu in., +22dBm out.
  • DISTORTION THD: .10% at peak levels; .005 at nominal levels; 20Hz to 20kHz
  • IMD: .05% maximum,
  • SMPTE RESPONSE: +/-.25dB 20 to 20,000 Hz
  • CROSSTALK & OUTPUT ISOLATION: 70dB min at 10kHz, a shorted output does not affect any other outputs.
  • NOISE: 20kHz bandwidth, -75dBm out at full gain.
  • INPUTS: 20k ohm active balanced, split and RF bypassed, 60dB
  • CMR: at 60Hz.
  • OUTPUTS: Active balanced, servo controlled, ground sensing, 50 Ohm output impedance, DC coupled. XLR type male connectors, Pin 2-HI, 3-LO, 1-GND.
  • OUTPUT LEVEL: +22dBm peak into 600 ohm balanced load; +18dBm peak typical into unbalanced loads.
  • SLEW RATE: 13 Volts per microsecond.
  • POWER: 115/230 VAC+/-10%, 47-63Hz, 20 VA.
  • SIZE: 19"W x 1-3/4"H x 7-1/2"D, 18lbs.
  • TERMINATIONS: XLR type, pin 1 grounded.
  • WARRANTY: Limited, One Year Warranty